Prepared by Dr. Aaron Scher
[email protected]
Oregon Institute of Technology

Back to Aaron's home page.

Note: To get the full tutorial experience, press play on all videos and watch/listen to them all at the same time.

1. How to perform a DC analysis using NI AWR Microwave Office

Download video here.

2. How to perform a transient analysis using NI AWR Microwave Office

Download video here.

3. How to perform a steady state AC analysis using NI AWR Microwave Office

Download video here.

4. How to optimize the design of a lumped element filter using NI AWR Microwave Office

Download video here.

5. How to use Microwave Office's TXLine to design a 50 Ohm microstrip line

Download video here.

6. How to use Microwave Office's EM Extract to setup and run EM simulation from the schematic

Download video here.

7. Basics of setting up and running an EM simulation (AXIEM) in AWR Design Environment (Microwave Office

Download video here.

8. Basics of performing an EM optimization in AWR Design Environment (Microwave Office)

Download video here.

9. How to import and analyze S-parameter touchstone data into AWR Design Environment (Microwave Office)

Download video here.

10. Microwave Office: Common & differential signals, even & odd mode modes, mixed mode S-parameters, and coupled microstrip transmission line pairs

Download video here.